Harvesting Plots with Case-IH Monitors

  Legacy, Mid-Range and Flagship Combines

 Harvested Rows per Entry are Less than Full Header Width

1. (A) Go to Toolbox, then Header (Mid-Range/Legacy) or Head 1 (Flagship)
2. Auto Cut Width should be Set to Off for Manual Operation
3. Overlap Mode should be Set to Manual
4. Leave Work Width Reset Mode Set to Manual

Go to RUN Screen Display (B) showing Full Header Width being used 

6. Top Left Box is Working Width, Top Right Box is Overlap Mode, Middle Window pops up when Working Width Box is tapped (B)

7. (C) Shows the Manual Adjustment of the Working Width

Soybean platform adjustment is the same as the corn head

8. Select Left or Right then Tap towards the opposite end to remove rows

Each Tap should be one row (or one unit of measure for a platform)

9. Rows that are BLACK will be mapping

Press ENTER when done adjusting Overlap

If Harvested Rows do not Match As-Planted Rows 

1. Go to DIAGNOSTICS Screen Display then VERSIONS (D)
2. For Automatic Variety Tracking VARIETY ZONE software must be loaded on the display.

3. (E) Shows a custom RUN screen setup for Variety Tracking
4. The top left box is Variety Tracking status and the top right box is Variety tracked
5. The large middle window, MAP 2x5, is not required for Variety Tracking
6. In normal field operations Variety Tracking should be set to ON and AUTO
7. Current variety harvested will be displayed in the Variety box
8. Varieties must be loaded from desktop software using a .CN1 folder

For Manual Tracking (F) Varieties must be loaded from desktop software (.CN1 folder) 

Varieties cannot be manually added in the field

10. Create a new Task and rename it every time a new Variety is harvested
11. Tasks will automatically close, and a new task created, once data limit is reached

This limit is usually around 40-60 acres