Case IH Pro 600 and Case IH Pro 700 version 28 & Below

1. Email your Account email, Field Names (and Field Numbers) with VRx to support@advantageacre.com to be converted to .cn1 files.

2. For Pro 600: Transfer .cn1 files to Compact Flash Card. NOTE: Case IH highly recommends using their own Compact Flash Card, Part # 84322404. Do NOT use more than 4GB flash cards.

For Pro 700: Transfer .cn1 files to USB flash drive. NOTE: Case IH highly   recommends using their own USB Flash Drive, Part # 4796296. Do NOT use more than 4GB flash drive.

3.  Insert the flash card into the monitor BEFORE starting your tractor!

4.  Go to Toolbox, Select Product. Verify correct VRx Setup.

• Hybrid/Variety Names
• VRx Min and Max (VRx bounds to prevent under or over planting)

5. Select Back in the lower left, go to the home screen, select Work Condition.

6.  At the bottom select the Layer tab.

• Assign work condition as you normally would when planting by selecting Work Condition and enter
• For LAYER 1 select Seed.
• For PRODUCT 1 select the Product that you will be planting in this field.

7. Go back to the Home screen and select

8. At the bottom, scroll to the right and select RX Setup.

• At the top, enable Auto Reload Rx.
• Select the corresponding Grower, Farm, and Field to the VR recommendation.
• Select Prescription 1, click the VR recommendation.
• Set the Out of Zone Rate 1. If GPS location is lost, the Out of Zone Rate 1 population will be planted until GPS location returns.

9.  VRx’s are loaded into your Pro 600/700v28 monitor. You are ready to plant!

Case IH Support                        855-423-7435

Advantage Acre Support         855-278-9134